| AZTECH 600E ADSL2/2+ | ADSL 2+ (BILLION) |
1.Click Setup
Management IP
2.Click New Connection-please key-in all the info
Click Advanced-Firewall-->Access Control.
Advanced-->DNS Proxy Server.
CONFIGURATION OF ZTE MODEM AS PPPoA
Go to http://192.68.1.1
-Click at Quick Setup
-Click Next
Click PPP over ATM (PPPoA)
Encapsulation Type =LLC/SNAP--click next
Click Obtain an IP address automatically
click Next
click next
Primary IP address:(please key in IP address)
Make sure Enable DHCP Server on the LAN is uncheck
Click Finish
-Go to Advance-LAN-please key in IP
Click Management
Click Remote Access-tick all the box except SNMP-Click Appy
Click Reset Router--click Reboot
Click SmartAX MT800A
-Click ATM setting-choose PPP
under Other Setting-Click LAN config
LAN IP ADDRESS : Please Enter IP address and Subnet Mask
Click DHCP Mode
Click DNS-202.188.0.133/202.188.1.5
NAT-Click Disable
Go to Basic--Quick Start
Click LAN Configuration
Click Advanced-WAN-quickstart
Click Advanced-Access Control
Home
2.PPP-Check the WAN configuration
4.LAN configuration
NAT
username:admin
password :password
1. Quick Start
2.Interface Setup-Internet
3.LAN
4.Advanced Setup
5.NAT
6.Access Management
7.Maintenance
8.Status
username:ZXDSL
password :ZXDSL
Go to Connection Settings--Create new connection service
Tick at PPP over ATM--Go to next step
Please enter username and password -->save
Click System Settings--DHCP-click at Enable DHCPServer-Automatic DHCP will disable --> Apply
System Settings--Local LAN IP-Please enter IP Address-Apply
Click Advance Settings--NAPT-Click at Enable NAT to internal interface-NAT automatic will disable
System Settings-->SDSL -->under ActivateLine please select TRUE to allow pinging and telnet into the modem
Click apply